"Flowzilla"

For Only $699 you receive all of the hardware pictured! 

• Flowzilla is the new inlet manifold from Kenne Bell for 5.0 Mustangs fitted with a "Twin Screw" supercharger.

• There is no better way to increase power from your Kenne Bell "Twin Screw" Supercharger than by decreasing inlet restriction.

• The Flowzilla offers virtually zero inlet restriction, even for air flow rates >1000 cfm!

• Look at these features of the awesome Flowzilla:

   

  • 43rwhp gain as tested by "5.0 Mustang and Fast Fords" magazine

  • 50% airflow increase  

  • Rated for 675HP!

  • Accepts 90mm Throttle Body

  • Integral Bypass Valve

  • Comes Completely Assembled, Ready to Bolt on and GO!

  • Polished or Satin Black Finish

  • Requires GT40 Manifold (we can supply)

  • Maximum gains are obtained with use of a 90mm mass air assembly (we can supply)

Customer Results with the Flowzilla:

Our customer Don LaSota installed a Flowzilla over the winter. Even with the addition of a 70# roll bar he gained over two tenths of a second and over 4 mph on his Kenne Bell supercharged Mustang convertible. This corroborates the expected 40hp gain from the Flowzilla. He ran 11.998seconds @ 117mph on a 3,700 pound car on drag radials and pump gas! This illustrates the massive torque from a Kenne Bell installation. Kennedy's recommends the Flowzilla as an effective  addition to your setup.